| RemoteMix Sport
Phone Line / Handset Interface
Overview | Details
| FAQs | Downloads
| Dealers
Three XLR Microphone Inputs with independent level controls. Mic 1 input is mic/line
switchable
Three 1/4" Headphone Jacks adjustable with "main feed" control.
1/4" Cue Input / Wireless Connection feeds only the headphones. Level adjustable
with "Cue Input" control. Also functions as wireless phone I/O jack using special 1/4" to
2.5 mm adapter cable provided.
Balanced XLR Output switchable between phone + mic mix or clean mic mix. Fixed level.
RJ-11 Jack for use with conventional phone lines. Also has an auxiliary handset
input for use as a standard telephone. Handset jack is biased for electret microphone types.
Universal Handset Interface for use with analog and digital PBX or ISDN telephones.
Three position switch will emulate electret, dynamic and carbon microphone types. This will
allow you to use your professional microphones and headphones with virtually any telephone
system.
Time Delayed Peak Limiter and VU Meter help to control transmit levels. The peak
limiter has a three second delay before clipping any audio. This allows for normal speech
patterns as well as brief exclamations to be broadcast unhindered.
Push to Talk Condenser Microphone and Monitor Speaker are a real help during equipment
setup and station breaks. Microphone push button mutes speaker to eliminate feedback and
switch disables speaker entirely after setup is complete.
|
Specifications
|
| Inputs: |
|
| Microphone: |
(3) Female XLR, 1k ohms, -10 mV RMS (-35 dBm nom.) Mic
1 has a Mic / Line pad switch, Line = +5 dBm nominal |
| Headphone Cue in: |
1/4" 20k ohms, 250 mV RMS (-10 dBm nom.) |
|
Outputs:
|
|
| Balanced out: |
Male XLR, 200 ohms, 500 mV RMS (+12 dBm Max.) |
| Headphones: |
(3) 1/4" Stereo, 8 ohms, 1/2 watt per channel |
|
| Two 9 Volt Batteries will power the unit for 28 hours. The batteries are
installed parallel so the unit can run on only one battery if necessary. An AC adapter
is also included with the unit.
DTMF / Pulse Keypad for dialing out. Tone/Pulse switch located under the battery
door.
Keypad Lockout Switch so accidental key presses are not blasted down the phone
line during a broadcast.
|
| Keypad: |
DTMF (Dual Tone Multi Frequency) / Pulse switchable.Auxiliary
Handset Jack, biased for electret microphone type handset. PBX Handset Interface biased
for Electret, Dynamic, and Carbon handsets. |
| Phone line: |
RJ11C, Isolation 1500 VAC |
| Ringer: |
1.2B REN |
| Size: |
6.5 x 4.6 x 2.2 inch (16.5 x 11.7 x 5.6 cm) |
| Weight: |
2.5 Pounds |
|
