| RemoteMix 3
Phone Line / Handset Interface
Overview | Details
| FAQs | Downloads
| Dealers
Two XLR Microphone Inputs with independent level controls. Mic 1 input
is mic/line switchable.
Two 1/4" Headphone Jacks adjustable with "Headphones" control.
RCA Line Input accepts line level signals. Adjustable with the "Line In"
control.
RCA Line Output delivers a line level signal containing the phone + mic mix. Fixed
level output.
Balanced XLR Output switchable between phone + mic mix or clean mic mix. Line level
output adjustable to mic level with the "Line Output" control.
Universal Handset Interface for use with analog and digital PBX or ISDN telephones.
Three position switch will emulate electret, dynamic and carbon handset microphone types.
This will allow you to use your professional microphones and headphones with virtually any
telephone system.
RJ-11 Jack for use with conventional phone lines. Also has an auxiliary handset
input for use as a standard telephone. Handset jack is biased for electret microphone types.
Time Delayed Peak Limiter and VU Meter help to control transmit levels. The peak
limiter has a three second delay before clipping any audio. This allows for normal speech
patterns as well as brief exclamations to be broadcast unhindered.
Push to Talk Condenser Microphone and Monitor Speaker are a real help during equipment
setup and station breaks. Microphone push button mutes speaker to eliminate feedback and
switch disables speaker entirely after setup is complete.
Made in USA
|
Specifications
|
Inputs: |
|
Microphone: |
Female XLR (2), 1k ohms, -10 mV RMS (-35 dBm nom.) Mic
1 has a Mic / Line pad switch, Line = +5 dBm nominal |
Line in: |
RCA, 20k ohms, 250 mV RMS (-10 dBm nom.) |
Outputs: |
|
Line out: |
RCA, 50 ohms, 250 mV RMS |
Balanced Out: |
Male XLR, 200 ohms, 500 mV RMS (+12 dBm Max.) |
Headphones: |
1/4" Stereo (2), 8 ohms, 1/2 watt per channel |
|
| Two 9 Volt Batteries will power the unit for 36 hours. The batteries are installed
parallel so the unit can run on only one battery if necessary. An AC adapter is also
included with the unit.
DTMF/Pulse Keypad for dialing out. Tone/Pulse switch located under the battery door.
Keypad Lockout Switch so accidental key presses are not blasted down the phone line
during a broadcast.
|
Phone line: |
RJ11C, Isolation 1500 VAC |
Ringer: |
1.2B REN |
Keypad: |
DTMF (Dual Tone Multi Frequency) / Pulse Switch located
under battery door.
Auxiliary Handset Jack, biased for electret microphone type handset. PBX Handset
Interface biased for Electret, Dynamic, and Carbon handsets. |
Size: |
6.5 x 4.6 x 2.2 inch (16.5 x 11.7 x 5.6 cm) |
| Weight:
|
2.2 Pounds |
|
